← Back to the full lesson

Heading, course, track, bearing and radial: summary

Definitions from the Pilot/Controller Glossary, the Pilot's Handbook of Aeronautical Knowledge (PHAK) and the Instrument Flying Handbook (IFH). Explanations, worked examples and practice: pilotscafe.com/heading-course-track-bearing-radial/

The five terms

HeadingThe direction the nose points. You control it, and air traffic control (ATC) assigns it in a vector.
CourseThe direction you intend to fly over the ground. The chart or the clearance sets it.
TrackThe path the airplane makes over the ground. In a crosswind it lies downwind of the heading.
BearingThe direction to or from a point. State which, and whether it is magnetic or true. To and from differ by 180°.
RadialA magnetic bearing from a very high frequency omnidirectional range (VOR), a tactical air navigation (TACAN) facility or a VORTAC. It depends on your position and not on your heading. A nondirectional beacon (NDB) has bearings and no radials.

All five terms on one diagram

West-southwest of the ABC VOR, on a vector to intercept the 240 radial inbound. True airspeed 120 kt, wind from 360° at 12 kt, all directions magnetic.

TermNumberWhere it comes from
Heading090°A vector, 30° from the course
Track096°Drift of 6° to the right (arctan 12 ÷ 120)
Course060°The reciprocal of the 240 radial
Bearing to the station070°The reciprocal of the 250 radial
Radial250°The airplane's position

Once on the course with the wind corrected: heading 055° (wind correction angle 5° left), track 060°, course 060°, bearing to the station 060°, radial 240.

Magnetic or true

MagneticRadials; courses on instrument charts; winds on voice broadcasts (the automatic terminal information service, ATIS, and automated weather stations).
TrueWinds in forecasts (winds aloft forecasts and terminal aerodrome forecasts).

A global positioning system (GPS) receiver may apply a different magnetic variation from the chart's, so its course can differ from the charted course.

Heading and track

  • Drift angle: the angle between heading and track.
  • Wind correction angle (WCA): the angle between the desired track and the heading needed to stay on it. When it matches the wind, track equals course.

Courses on a radial

  • Outbound: the course equals the radial (060° on the 060 radial).
  • Inbound: the course is the radial ± 180° (060° on the 240 radial).
  • Set the omnibearing selector (OBS) to the course you intend to fly. On the reciprocal, the course deviation indicator (CDI) shows reverse sensing.

Relative bearing

Relative bearing is measured clockwise from the nose to the station. A fixed-card automatic direction finder (ADF) shows it.

Magnetic bearing to the station = magnetic heading + relative bearing (subtract 360° from a sum over 360°): 090° + 340° − 360° = 070°.

On a radio magnetic indicator (RMI), the head of the needle shows the magnetic bearing to the station and the tail shows the bearing from it.

Where each term appears

"Fly heading 090"A vector. Turn to the heading and maintain it.
"Vector to intercept the ABC two four zero radial"Fly the heading until the CDI centers, then turn onto the radial.
"Cleared direct ABC"Fly a straight line to the fix.
"Resume own navigation"Navigate by your own means again.

GPS fields (Garmin)

DTKDesired track: the course between the active waypoints.
TRKTrack: the direction the airplane is moving over the ground.
BRGBearing: the direction from your position to the waypoint.
XTKCrosstrack error: your distance left or right of the course.

On the course, DTK, TRK and BRG are about equal and XTK is zero. TRK equal to DTK with an XTK showing means you are flying parallel to the course.